Posts Tagged ‘repair’

This is one of my upcoming restoration projects. There is also a mystery tape with it.

The repair specialists at Deltronics have to be more than just technicians — they have to be grief counselors, father confessors and even detectives as well. Sometimes, customers will walk into Deltronics electronics repair service with their head hanging low, avoiding all eye contact, pretending to not know what, exactly, happened to their beloved Otari MX-5050, that it just “stopped working.” Sometimes, you just put your head down, get out the rubber solvent and lube grease, and go to work. See more on Gearwire.com.

The repair specialists at Deltronics have to be more than just technicians — they have to be grief counselors, father confessors and even detectives as well. Sometimes, customers will walk into Deltronics electronics repair service with their head hanging low, avoiding all eye contact, pretending to not know what, exactly, happened to their beloved Otari MX-5050, that it just “stopped working.” Sometimes, you just put your head down, get out the rubber solvent and lube grease, and go to work. See more on Gearwire.com.

www.espares.co.uk If taken care of properly your Numatic vacuum cleaner will last you years to come. In this video Matt will show you how to replace the cable ree and cable on a Hetty vacuum cleaner.

Important fishing secrets related to fishing reels and olfactory capabilities that fish possess. Its possible to transfer abhorrent odors from fishing reels, to the line, to the water, and to holding fish. Easy trick to keeping fish on the bite is to rinse, lightly wash, reels at the end of the day. Because monofilament is porous its important to change out fishing line that may have come within contact adherent odors.

Expert studio engineer shows how to clean the pressure roller of a reel-to-reel tape deck in this free stereo-repair video on restoring a reel-to-reel tape deck.Expert: Kurt Glaser Bio: Kurt Glaser has been doing electronic calibration of audio gear since the early 70′s. He is owner/chief recording engineer of KGB Studios in Redmond, WA. Filmmaker: kurt glaser

Yes, a classic! A LOT of work I did to fix this, I replaced all the electrylitic capacitors, but still didn’t fix a weak amp. I replaced a bad transistor and it fixed the amp. I also replaced the belt, as it was LOOSE. I re-did a spring for the take-up reel idler and lubricated the spinning parts with 3-in-1 oil. DC bias on this one, but surprizingly good for DC bias and the S sounds normal.

Find out what repair tools are needed for doing restoration of a reel-to-reel tape deck in this free stereo-repair video taught by ourstudio engineer. Expert: Kurt Glaser Bio: Kurt Glaser has been doing electronic calibration of audio gear since the early 70′s. He is owner/chief recording engineer of KGB Studios in Redmond, WA. Filmmaker: kurt glaser

Watch a video introduction of restoring a reel-to-reel tape deck and what tools are needed, in this free stereo-repair video taught by ourstudio engineer. Expert: Kurt Glaser Bio: Kurt Glaser has been doing electronic calibration of audio gear since the early 70′s. He is owner/chief recording engineer of KGB Studios in Redmond, WA. Filmmaker: kurt glaser

You’ll need several tools for the alignment of heads of a reel-to-reel tape deck; learn more in this free stereo-repair video from ourstudio engineer. Expert: Kurt Glaser Bio: Kurt Glaser has been doing electronic calibration of audio gear since the early 70′s. He is owner/chief recording engineer of KGB Studios in Redmond, WA. Filmmaker: kurt glaser